Successful Application Of Alumina Ceramic Balls in Iron Ore Beneficiation At Steel Mills

Nov 13, 2026

Leave a message

Practical Application Cases and Data

The industrial pilot test conducted at Shougang's Dashihe Iron Mine offers the greatest reference value. In the secondary ball-milling stage, the mine replaced conventional iron balls with ceramic balls; results showed that the secondary ball mill achieved an hourly electricity savings rate of over 40%, exceeding the 30% target set at the project's initiation. This figure is based on actual production validation at the steel plant's own mine, rather than on laboratory estimates.

The magnetite beneficiation plant under Baotou Steel Group has also conducted a feasibility study. With regard to the secondary fine-grinding stage of the magnetite deposits at Baiyun Ebo, the conclusion is that "partially replacing steel balls with ceramic balls as the media for secondary fine grinding is entirely feasible."

In addition, some companies have disclosed application data for their nano-composite balls in the second and third-stage grinding of iron ore: they can reduce the current in stand mills and ball mills by 50%, decrease the charge volume by 40%, result in wear that is only one-quarter that of steel balls, and increase the grade of iron concentrate by an additional 2–3 percentage points.

Why It Works: The Advantages of Ceramic Balls

The density of alumina ceramic balls is significantly lower than that of steel balls (approximately 3.8 g/cm³ vs. 7.8 g/cm³ for steel balls); consequently, for the same volume, their weight is reduced by nearly half, substantially lowering the operating load of the ball mill and providing a direct source of electricity savings. Additionally, ceramic balls have high surface hardness (Mohs hardness ≥ 9) and excellent wear resistance, requiring only small supplemental dosages and resulting in lower long-term operating costs. For iron ore processing, ceramic balls also do not introduce iron contamination, which facilitates subsequent separation and beneficiation.

Key limitation: It is effective only when used in the correct position.

The successful application of ceramic balls has one important prerequisite: they are suitable for fine grinding but not for coarse grinding. Industry practice has shown that if the feed particle size in a ball mill is too coarse (e.g., above 6–8 mm), the impact load increases, creating a risk of ceramic-ball breakage. Consequently, in practical applications, ceramic balls are typically used in two-stage grinding, three-stage grinding, or tailings re-grinding-stages in which the feed is already relatively fine-rather than in a single-stage coarse-grinding stage. Shougang's tests were likewise conducted during the "secondary ball milling" process.

Simply put, the successful application of alumina ceramic balls in iron ore beneficiation at steel mills is well documented; their core value lies in reducing power consumption and lowering energy use during the second stage and subsequent fine-milling stages, rather than in completely replacing steel balls throughout the entire process.

 

Wear-resistant Alumina Ball

Contact person:Sabrina Sun

Whatsapp/wechat:+8618369949806