Process Flow Of Ceramic-Lined Pipe Wear-Resistant Elbows

Nov 13, 2026

Leave a message

The mainstream production processes of ceramic-lined wear-resistant elbows can be divided into three major categories: patch bonding reinforcement, self-propagating high-temperature synthesis (SHS), and overall high-temperature sintering. The applicable scenarios and process details of different processes vary significantly. The following are the complete standardized procedures for each process.



This process is currently the most widely used solution, suitable for large-diameter and non-standard special-shaped elbows with short production cycles and controllable costs. It is suitable for medium and low-temperature conditions and fine powder material transportation.

Elbow Substrate Pretreatment

Use sandblasting to raise the internal wall rust removal level to Sa3

Control roughness at Ra3.2μm

Completely remove oil, grease, and oxide scales

Ensure surface is dry and dust-free after alcohol wiping

Ceramic Tile Customization and Pre-layout

Select alumina ceramic tiles with Al₂O₃ content ≥95%

Cut into fan/arc shapes using diamond cutting discs according to elbow curvature

Mark positions on the inner wall of the elbow for staggered arrangement

Control joint gaps ≤0.5mm

Adhesive Preparation and Bonding

Precisely mix high-temperature resistant and wear-resistant adhesive

Evenly apply 1-2mm thick adhesive layer on both sides

Press and fit ceramic tiles, gently tap with rubber hammer

Temporarily fix vertical parts with high-temperature tape to prevent slipping

Welding Mechanical Reinforcement

Set 4-8 weld points per ceramic tile

Use argon arc welding with low current spot welding

Use compressed air for cooling during welding

Control ceramic surface temperature ≤150°C to avoid thermal shock cracking

Curing and Post-processing

Cure at room temperature for 24h or at 80°C for 2h

Grind weld burrs and excess adhesive layers

Repair gaps between tiles with wear-resistant filler

Finished Product Quality Inspection

Use percussion method to check for hollowing (hollowing rate ≤5%)

Conduct 1.5 times rated working pressure hydrostatic test for 30min without leakage

Ultrasonic testing ensures ceramic lining thickness uniformity error ≤0.5mm



This process utilizes chemical reaction heat to generate ceramic layers with high bonding strength, suitable for small and medium-diameter elbows, widely used in thermal power and metallurgical industries.

Elbow Substrate Preparation

Use seamless steel pipes to hot-press form elbows at specified angles

Grind inner walls to remove burrs

Control ovality within 2-3mm after rounding

Reaction Material Filling

Mix aluminum thermite (aluminum powder + iron oxide powder) in proper proportions

Fill into the elbow and seal both ends

Centrifugal Reaction Synthesis

Fix the elbow on centrifugal equipment

Ignite reaction mixture to generate dense corundum ceramic layer at >2200°C

Centrifugal force ensures uniform attachment of molten ceramic to inner wall

Cooling and Demolding

Control cooling rate to avoid cracks in ceramic layer

Clean excess materials from both ends after cooling

Precision Processing and Inspection

Machine welding grooves at pipe ends

Conduct hydrostatic test and ultrasonic flaw detection

Ensure ceramic layer has no delamination or cracks

 

 

http://www.chenyiceramic.com/ceramic-lined-pipe/wear-resistant-alumina-ceramic-lined-bend.html

 

Please contact Cathy Wang through email: sales@zbchenyi.com or WhatsApp: +0086 13969321722